Kohler K-1110 Guide D'installation page 23

Air Flow Mode
Activates Mode Selected
Rotate Outer Ring to
Access Desired Mode
Power On/Off
Chromatherapy Specific
Color (if provided)
15. Test Run the Bath with Airjets - Remote
For additional information on bath with airjets operation, see "Confirm Proper Operation" section.
Check all electrical connections, and make sure the electrical power to the bath is turned on.
Make sure all PVC piping connections are properly made.
Temporarily remove the protective drop cloth from the bath.
Ensure that the area around the blower motor is clean and free of dust or debris.
Fill the bath to a level at least 2" (5 cm) above the top of the highest airjet.
Press the power button to start the bath.
Observe that air flow is present in all three zones of the bath with airjets.
Check all bath PVC connections for leaks.
Stop the blower.
Check for any water leakage at the bath, the bath drain, and the air harness.
Test other features as desired by rotating the outer ring on the keypad and pressing "OK."
Drain the bath and observe that the purge cycle starts.
Allow the automatic purge cycle to complete.
Reinstall the protective drop cloth in the bath.
Turn off power to the unit.
Kohler Co.
All manuals and user guides at all-guides.com
Zone 1
Rotating Ring Key Pad
23
Zone 2
Zone 3
Surge Mode
Increase Flow or Surge
Indicator Bar
Decrease Flow or Surge
Chromatherapy Cycle
(if provided)
Purge Mode
1035472-2-G