KRESS 500 ST E Mode D'emploi page 15

Original instructions "Jig saw"
Symbols and abbreviations
1. Symbols and abbreviations
The symbols used in these instructions and, if ap-
plicable, on the power tool serve to bring your at-
tention to potential dangers when working with
this power tool. You must understand the signifi-
cance of these symbols/notes and comply with
them in order to make its use more efficient and
safer.
The safety warnings, notes and symbols are not a
substitute for regulation measures for accident
prevention.
Symbols
User action
Action for working with the device,
start with light pressure and increase
the pressure slowly until the desired
operation is achieved.
Follow the instructions in numerical
order.
OFF / Standstill
ON / Working position
Maintenance and installation instruc-
tions - Rotary motion
Tasks or actions which require a lock.
Recommended by the manufacturer
Further information see Page 26
Illustrated or described accessories
are not necessarily included in the
scope of delivery
Technical modifications reserved
Especially important note for safety.
Always follow this note, otherwise it
could result in severe injury.
Warning of dangerous electrical volt-
age
Warning of hot surfaces
-WARNING-
For a potentially dangerous situation which could
lead to physical injury or material damage.
-NOTE-
Modification notes and other useful information.
2. Safety rules
General safety instructions for power
tools
WARNING!
Read all safety warnings and all
instructions.
Failure to follow the warnings and
instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for
future reference.
The term "power tool" in warnings refers to your
mains-operated (corded) power tool or battery-op-
erated (cordless) power tool.
Work area
Keep work area clean and well lit.
Cluttered and dark areas invite to accidents.
Do not operate power tools in explosive atmos-
pheres, such as in the presence of flammable liq-
uids, gases or dust.
Power tools create sparks which may ignite dust
or fumes.
Keep children and bystanders away
while operating a power tool.
Distractions can cause you to lose
control.
Electrical safety
Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any adapt-
er plugs with earthed (grounded) power tools.
Unmodified plugs and matching outlets will reduce
risk of electric shock.
English 15
EN
ST-EN / 0902