Publicité
Les langues disponibles
Les langues disponibles
Installation Steps
Front Flare Bracket
Rear Flare
11.
Remove and discard factory mudflap in front of wheel well opening. Remove four factory fasteners from rear of wheel well. Retain two 7mm
screws for reinstallation. Thoroughly clean the vehicle sheet metal and inner flange prior to installation.
12.
Hold flare to vehicle and mark three flare hole locations with a grease pencil. (See Illustration below.)
13.
Wrap a Mylar Tab (MT1-0014) around the wheel well sheet metal, centered over each of the three marks made in Step 12.
14.
Install a S-Clip (CL1-0005) over each of the three Tabs (MT1-0014) placed over the upper 3 marks made in Step 13.
15.
Reinstall two factory 7mm screws. Install two Panel Retainers (RV1-P008).
16.
Press flares firmly onto the vehicle and install and fully tighten three screws (SW1-0050) into the clips installed in Step 14.
17.
Completed rear flare installation.
FRONT OF VEHICLE
Rubber Seal
Inner side of
fender flare
Use Rubber Seal here
Do NOT use Rubber Seal here
NOTE: Actual application may vary slightly from illustrations.
XXXXXX
Step 12 mark
Black Mylar
Tab
S-clip
Truss
Screw
Retainer
Factory 7mm screw
Page 3 of 4
Step 6. Install bracket
XXXXXX
Publicité
