Publicité
Les langues disponibles
Les langues disponibles
Preparation Before Painting / Installation
Cleaning the vehicle.
Make sure to wash your vehicle, especially the area the fender flares will be mounted to including the inner fender lip. Any dirt or debris that has not been cleaned or
removed can potentially cause the improper fitment of the fender flare. If you are covering existing rust, we recommend sanding down the rust and primer over to prevent
further deterioration of the metal in the fender. Make sure the vehicle is dry before the installation. The fender flares come ready to be installed, however if you need to
clean them, please use a mild detergent to wash and then dry completely.
For RX Style Only (SKIP if you have SX or EX style)
Install the rivet screws and nuts to each of the rivet holes on the flare. Our rivets are designed to screw on to the fender flares only, and they shouldn't be touching the
vehicle body at all. Using hand tools, tighten nuts until fastener is snug. DO NOT OVERTIGHTEN as this may damage the fender flare.
Installation of the Rubber Seal
Before you start cutting any rubber seal, please study the diagram. Do not use the rubber seal in any other areas other than indicated; otherwise you will end up with
a shortage of rubber seal on your last flare. Start the installation of the rubber seal as indicated in the diagram. Then cut the rubber seal with a razor. Follow the same
instruction for the remaining flares.
*Each roll of the rubber seal provided is long enough to complete the 4 fender flares and with extra to spare, however we are not responsible for the improper use of
the rubber seal. Contact Lund International to purchase additional rolls of rubber seal.
Installation Steps
Front Flare
1.
Remove seven factory screws with a socket wrench. Note that (1) location farthest to the front where screw is not to be removed.
Save screws for reinstallation.
2.
Hold flare to vehicle and mark one flare hole location with a grease pencil. (See Illustration below)
3.
Wrap a Foam Tab (MT1-0034) around the wheel well sheet metal, centered over the mark made in Step 2.
4.
Install a Clip (CL1-0009) over the Tab (MT1-0034) placed in Step 3.
5.
Verify presence of U-clip on inner brackets.
6.
Line up the holes in the inner bracket with the three uppermost factory holes. NOTE: Both inner brackets are universal. (See illustration page 2)
7.
Using a socket wrench, reinstall the factory screws through the inner piece.
8.
Hold flare to fender, re-install three factory screws removed in Step 4 using sockets and wrench.
9.
Position flare on fender, pressing inward on the flare, line up the flare mounting holes with the mounting clips on the inner
piece. Install four Phillips Truss Screws (SW1-0058) through the flare and into the clips on the inner piece. Install and tighten.
10.
Completed front flare installation.
FRONT OF VEHICLE
Rubber Seal
Inner side of
fender flare
Use Rubber Seal here
Do NOT use Rubber Seal here
NOTE: Actual application may vary slightly from illustrations.
XXXXXX
Factory screw
truss
screw
Factory screw
Page 2 of 4
Step 2 mark
Black
Foam Tab
U-Clip
XXXXXX
Publicité
