Publicité
Les langues disponibles
Les langues disponibles
W 510
2. If the feed rate is too low even at maximum flow setting, dilute in steps of 5 - 10 % until
the feed rate meets your requirements.
10. Start-up
Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
•
Unscrew the container from the spray gun.
•
Aligning suction tube. (Fig. 2)
If the suction tube is positioned correctly, the container contents can be sprayed without
almost any residue.
When working on lying objects: Turn the suction tube forwards. (Fig. 2 A)
Spraying work when working on overhead objects: Turn the suction tube rearwards.
(Fig. 2 B)
•
Place the container on a paper base and pour in the prepared coating substance with
the aid of the feed hopper included in the scope of supply. Screw the container tightly
onto the spray gun.
•
Connect the front part with the rear part of the gun (Fig. 3).
•
Put the machine down only on a level, clean surface. Otherwise the machine could tip
over!
•
Pull the trigger. The W 510 has a two-stage trigger. In the first stage the turbine is started.
If the trigger guard is pressed further, the material is transported.
•
Adjust the spray setting on the spray gun.
The enclosed practice poster is ideal for familiarising yourself with operation
The enclosed practice poster is ideal for familiarising yourself with operation
i
of the spray gun.
of the spray gun. After trying out the first spray coatings, it makes sense to
test it further on cardboard or a similar surface in order to find out the right
test it further on cardboard or a similar surface in order to find out the right
flow rate of paint and air for the best spray pattern.
flow rate of paint and air for the best spray pattern.
11. Selecting the Spray Setting
WARNING! Danger of injury! Never pull the trigger guard while adjusting
the air cap.
With the union nut (fig. 4, 1) slightly unscrewed, turn the air cap (2) to the desired
spraysetting position (arrow). Then tighten the union nut.
Fig. 5 A = vertical flat jet
Fig. 5 B = horizontal flat jet
Fig. 5 C = circular jet
After trying out the first spray coatings, it makes sense to
for horizontal surfaces
for vertical surfaces
for corners, edges and hard-to-reach surfaces
EN
25
Publicité
