SICE S 100 PL Manuel D'instructions page 82

CORRECT PROCEDURE FOR
DEMOUNTING/MOUNTING
RUN FLAT TYRES WITH
STRAP-ON SENSOR
NB: the sensor is at 180° to the tyre valve.
Tyre demounting
air out of the tyre.
sensor that should be at 180°.
9 o'clock).
rotational bead breaking stage.
upper bead breaking until the sensor is
at 12 o'clock (valve at 6 o'clock) and not
beyond.
12 o'clock).
gripper at 2 o'clock.
lower bead.
o'clock).
head.
with the bead breaker disc in the down
position.
care not to damage the sensor.
82
Tyre mounting
o'clock)
head and starts to be mounted on the rim.
o'clock).
presser gripper to be inserted at 3 o'clock.
(2 or 3 inches) to keep the upper bead of the
tyre inside the open centre during rotation.
adjustments until the upper bead has been
mounted.
a second Run-Flat gripper and/or the bead
presser accessory, if available.
Run-Flat grippers used.
bead insertion.
INFLATION
WARNING
Inflation is well known to be a dangerous
operation. It must be carried out in accor-
dance with the instructions below. Safety
goggles with plain lenses and safety footwear
must be worn.
CAUTION
During this operation, noise levels assessed
at 85 dB(A) may occur. Operators are advised
to wear hearing protection devices.
DANGER
Although the machine limits the pressure, it
does not provide sufficient protection if the
tyre bursts during inflation.
Failure to comply with the instructions below
will render tyre inflation dangerous.
User Manual S 100 PL