Publicité
Les langues disponibles
Les langues disponibles
installation
(continued)
discharge to the outside
The discharge should not be connected to a duct which is
also used for other purposes under any circumstances.
Bear in mind any local regulations concerning the ventilation
of gas appliances.
The discharge may pass straight through the wall to the
outside, provided that the wall opening is protected - by
means of a grating - against rain, leaves, and the like getting
in. The passage of the discharge may not be restricted by
the wall grating by more than 20%.
We advise the use of as large a discharge duct as possible.
A duct with a smaller diameter will have a low extraction
capacity and produce higher noise levels. Bends produce
resistance. Make sure that the duct has a smooth run and
has as few bends as possible. Draw the flexible pipe out as
far as possible. Before starting to drill, check that there are
no installed pipes present.
The discharge stump has a diameter of 150 mm. It is best if
the discharge pipe also has this diameter.
A reducing piece (150 mm to 125 mm) is supplied with the
appliance for connection to a 125 mm discharge pipe.
GB 12
All manuals and user guides at all-guides.com
assembly
building-in dimensions
292
cut out dimensions
827 (WU9011PM)
1132 (WU1211PM)
406
320
822
206
857
468
WU9011PM
411 (WU9011PM)
411 (WU9011PM)
563 (WU1211PM)
563 (WU1211PM)
822 (WU9011PM) - 1127 (WU1211PM)
857(WU9011PM) - 1162 (WU1211PM)
411
406
320
1127
206
292
1162
468
WU11PM
306
86
100
468
WU9011PM:
411 x 827 mm
WU1211PM: 411 x 1132 mm
GB 13
Publicité
