Publicité
Les langues disponibles
Les langues disponibles
BRAKES
1
2
ELECTRICAL SYSTEM MAINTENANCE
REMOVING THE BATTERY
2
1
Install the new pads.
Reinstall the retaining pins
Check the brake fluid level and fill if necessary
( p.125 and p.126).
CAUTION
Do not use the bike until the brake lever and the pedal are
operational. ÿPumpŸ the brake lever / brake pedal up and down
until the brake pads are in contact with the discs.
Turn off all electric devices and stop the engine.
CAUTION
3
WAIT AT LEAST 30 SECONDES BIKE TURNED OFF AND STOPPED
SO THAT THE KEYLESS SYSTEM TURNS OFF.
IF THIS IS NOT DONE THERE IS A SIGNIFICANT RISK OF DAMAGE
TO THE COMPUTER (ECU)
- Remove the seat ( p.112).
- Remove the air filter ( p.112).
The battery is located at the bottom of the filter housing.
- Remove the two screws
retaining bracket.
- Disconnect the negative cable from the battery
- Disconnect the battery positive cable
- Remove the battery from the top.
and clips
.
2
1
that retain the battery
1
.
2
.
3
129
Publicité
