Velleman ED91010 Notice D'emploi page 3

1. Introduction
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, do not install or use it and contact your dealer.
2. Safety Instructions
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
• Damage caused by user modifications to the device is not covered by the warranty.
• Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
• Check the contents prior to assembly. Use proper tools and never use defective or deformed
parts as an improper installation may cause serious injury.
• Any included hardware is for mounting on solid brick, concrete or hard wood battens.
When mounting on wood, do not use any concrete anchors. Do not use any included hardware
for mounting on steel. If uncertain about the nature of the wall or mounting techniques, please
consult an expert.
• Respect the product's max. load specifications. Protect this device from shocks and abuse and
avoid brute force when operating. Check the installation on a bimonthly basis.
• An adequate mounting is essential and falls outside the responsibility of Velleman Components
nv. Respect all installation and operating directions of the device to be mounted/installed
(LCD/plasma display).
• Only use the device at an indoor location, protected from rain, moisture, splashing and dripping
liquids. Make sure the chosen location spot is able to support the weight of the bracket and
screen.
• Keep fingers away from articulations to avoid injury. Keep the device out of reach of children and
unauthorized users at all times.
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
4. Features
• for LCD TV
• easy installation
• in accordance with VESA standard 75/100mm
• comes with all necessary plugs and screws for assembly and mounting
5. Installation
Refer to the illustrations on page 2 of this manual.
• Detach the TV mounting bracket from the wall mounting bracket by removing the top nut.
1) use the wall mounting bracket to determine and indicate the position of the mounting holes
(arrow pointing up)
2a) when mounting on a brick or concrete wall, drill holes size Ø8mm at the indicated positions
2b) when mounting on a wooden wall or wall support, drill holes size Ø2mm at the indicated
positions
3a) for concrete or brick walls, insert the included screw anchors into the holes and screw the wall
mounting bracket firmly on the wall with the included screws
3b) for wooden walls or wall supports, screw the wall mounting bracket firmly on the wall using
wood screws
4) mount the TV mounting bracket on the back of the TV
5) attach the TV mounting bracket (with TV) back to the wall mounting bracket
6) hold the tv-screen in the desired horizontal angle and secure its position by screwing the top
nut back in place
• To change the vertical angle of the TV-screen, loosen the screw at the side of the wall mounting
bracket. Position the TV-screen and tighten the screw firmly.
09/12/2008
WB010 - WB011
User manual
3
© 2008 Velleman Components nv