Publicité
Les langues disponibles
Les langues disponibles
SERVICE
PROCEDURES
Continued
FAN
1. Remove three screws that attach fan
guard to heater shell.
2. Remove motor and fan guard from
heater shell (see Figure 14).
3. Use hex wrench to loosen set screw that
holds fan to motor shaft (see Figure 15).
4. Remove fan. Be careful not to damage
the fan blade pitch.
5a. If replacing fan, remove old fan and
discard. Go to step 7 below.
5b. If cleaning fan,use soft cloth moistened
with kerosene or solvent.
6. Dry fan thoroughly.
7. Place fan onto motor shaft. Make sure
set screw contacts flat surface on mo-
tor shaft. Tighten set screw firmly (40-
50 inch-pounds).
8. Place motor and fan guard into rear of
heater shell. Make sure power cord is
properly located (see Figure 16).
9. Insert three screws through heater shell
and into fan guard. Tighten screws
firmly.
Figure 14 - Removing Motor and Fan
Guard from Heater
105339
Setscrew
Figure 15 - Setscrew Location
Figure 16 - Replacing Motor and Fan
Guard into Heater
IGNITOR
1. Remove motor and fan guard from
heater (see Motor, page 8, steps 1
through 5).
2. Remove black ignitor wire from piezo
ignitor. Access ignitor wire through
underside of heater base (see Figure
17). Push wire up through bushing in
heater shell.
3. Remove ignitor mounting screw from
rear head using nut-driver or standard
screwdriver (see Figure 18).
4. Remove ignitor from rear head.
5. Install new ignitor. Attach ignitor to rear
head with ignitor mounting screw.
6. Run ignitor wire from new ignitor
through bushing in heater shell. Attach
ignitor wire to piezo ignitor.
7. Set gap between ignitor electrode and
target plate to 4.3 mm (.17 in) (see Fig-
ure 19).
9
OWNER'S MANUAL
WARNING: Make sure heater
is disconnected from propane
supply. Heater could ignite caus-
ing severe burns.
8.
Test for spark. Push piezo ignitor but-
ton and watch for spark between igni-
tor electrode and target plate.
9.
Place motor and fan guard into rear of
heater shell (see Motor, page 8, steps 9
and 10).
Ignitor Wire
Figure 17 - Removing Ignitor Wire from
Piezo Ignitor
Rear
Head
Ignitor
Mounting
Screw
Figure 18 - Removing Ignitor Mounting
Screw and Ignitor
Target Plate
Figure 19 - Clearance between Ignitor
Electrode and Target Plate
Piezo
Ignitor
Bushing
Underside of Heater Base
Ignitor
Ignitor
Electrode
Gap
Area
Publicité
