Publicité
Les langues disponibles
Les langues disponibles
11. Automated Learning Process./Activating Code.
CAUTION: The wall or handheld remote control can be programmed to multiple receivers or fans. If this is not
desired, turn wall switch off to any other programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on wall control to the ON position.
Within 60 seconds of turning on the wall control, press and hold the fan OFF button on the wall control for
5 seconds or until light blinks twice.
Turn power off again for at least 5 seconds and then turn power back on. Within 60 seconds of restoring
the power, press and hold the fan OFF button on the front of the handheld remote control for 5 seconds or
until light blinks twice.
Test the light and fan functions to confirm the learning process is complete--see Section 13 .
12. Remote Control Operation.
ON/OFF
-
slider switch
HIGH button
-
MED button
-
LOW button
-
OFF button
-
L1 button
-
13. Testing Your Fan.
It is recommended that you test fan before finalizing installation.
Restore power from circuit box and light switch (if applicable). Test
wall control (optional installation) by locating ON/OFF slider switch
on wall control, then set to the ON position. Test light and dimmer
function and then test fan speeds. Next, locate handheld remote
control. Test the light ON/OFF function by pressing the L1 button;
test the dimmer function by pressing the L1 button and holding it
down for 1 second. Test fan speeds with the different fan speed
buttons. If the wall or handheld remote control operates all of the
functions of the fan, battery has been installed correctly. If the wall
or handheld remote control does not operate all of the fan/light
functions, refer to "Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off before moving the reverse switch (located
under the yoke cover on the motor housing). Set reverse switch to
recirculate air depending on the season:
- LEFT position in summer (diagram 1)
- RIGHT position in winter (diagram 2)
A ceiling fan will allow you to raise your thermostat setting in
summer and lower your thermostat setting in winter without feeling
a difference in your comfort.
Important: Reverse switch must be set either completely to the LEFT
or completely to the RIGHT for fan to function. If the reverse switch
is set in the middle position (diagram 3), fan will not operate.
NOTE: If the wall control or handheld remote control interferes with
other appliances, follow instructions in Section 11.
turns wall control ON or OFF
(switch not functional on handheld
remote)
turns fan to HIGH speed
turns fan to MEDIUM speed
turns fan to LOW speed
turns fan OFF
turns light kit ON/OFF when pressed once;
dims light kit when pressed and held
down
page 11
-
1 1
wall control
handheld
remote control
reverse switch
diagram 2
diagram 1
diagram 3
Publicité
