Please Read Immediately; Important Information; Intended Use; Regulations / Safety Information - Dimplex BWP 20A Instructions D'installation Et D'utilisation

1
1 Please Read
Immediately

1.1 Important Information

ATTENTION!
The device cover cannot be used for carrying (the cover cannot withstand
larger forces!)
ATTENTION!
Hot water, cold water and circulation connections: These pipe nipples
contain plastic inserts which serve to protect against corrosion (in
particular to the pipe nipple flange surfaces). These plastic inserts remain
in their positions after the water pipes have been installed.
ATTENTION!
Only operate hot-water heat pump when filled with water!
ATTENTION!
Disconnect the power supply before opening the hot-water heat pump;
observe possible coasting of ventilator.
ATTENTION!
Ensure water does not come into contact with the operator controls.
Unplug mains plug/disconnect the power supply before beginning any
cleaning work.

1.2 Intended Use

This device is only intended for use as specified by the manufac-
turer. Any other use beyond that intended by the manufacturer is
prohibited. This includes the user's abiding by the manufacturer's
product brochures. Please refrain from tampering with or altering
the device.
EN-2
1.3 Regulations / Safety
Information
ATTENTION!
Read these installation and operating instructions before start-up!
 The hot-water heat pump is exclusively used to heat water
for domestic use and drinking water within the specified op-
erating temperature limits! Heating fluids is not permitted.
Observe the technical regulations for domestic water instal-
lation (DIN 1988).
 Exhaust air should not fall below +15 °C (evaporator may
freeze). Sinking exhaust air temperatures reduce economi-
cal heat pump operation.
 It is not permitted to
operate the pump with solvent-laden or explosive exhaust
-
air
- use exhaust air containing fat, dust or sticky
aerosols
- to connect extractor hoods to the
ventilation system
 Installation of the device is not permitted
- outdoors
- in rooms which are exposed to frost
- in rooms with air which is potentially explosive
because of gases, vapours or dust
 Operation of the device is not permitted
- with an empty cylinder
 The construction and design of the hot-water heat pump
complies with all relevant EG directives (see also CE decla-
ration of conformity).
 The technician must ensure that the refrigerant is flushed
adequately to allow maintenance and repair work on refrig-
erant circuit components without risk. Refrigerant must be
properly used and disposed of; it must not be released into
the environment!
The refrigerant circuit is hermetically sealed. It contains the
Kyoto protocol approved refrigerant R134a with a GWP
value of 1300. It is CFC-free, does not deplete ozone and is
non-flammable.
 When working on the hot-water heat pump, always discon-
nect the power supply.
 When connecting the hot-water heat pump to the power sup-
ply, the relevant VDE, EN and IEC standards are to be ful-
filled. Also observe the technical connection requirements of
the electrical utility companies.
 This heat pump is designed for use in a domestic environ-
ment according to Article 1, Paragraph 2 k) of EC directive
2006/42/EC (machinery directive) and is thus subject to the
requirements of EC directive 2006/95/EC (low-voltage direc-
tive). It is thus also intended for use by non-professionals for
heating shops, offices and other similar working environ-
ments, in agricultural establishments and in hotels, guest
houses and similar / other residential buildings.
ATTENTION!
Work on the hot-water heat pump is to be performed by qualified
personnel only!
Observe accident prevention regulations!