Morphy Richards TOTAL CONTROL Mode D'emploi page 10

FP403040MEE Rev1.qxp_Morphy Richards Instruction Book 11/07/2016 17:38 Page 10
the Manual Speed Settings never run it for longer than 60
seconds and allow to cool for 5 minutes. Switch off as soon as
you have reached the desired consistency.
• The machine will not work if the Plastic Jug (5) is fitted incorrectly.
• Don't use the Plastic Jug as a storage container. Keep it empty
when not in use.
• Never blend more than 1 litre (1 3⁄4 pints) - of frothy liquids, such
as milk shakes.
• If using a max of 1.5L do not use any higher than speed 2.
• When blending soup do not fill over the
1 Litre mark.
• Do not overfill the blender. This could cause
damage to the motor. The plug fuse will blow if the blender is
overloaded. Replace the fuse and do not exceed the maximum
recommended volumes. Refer to the 'Operating chart'.
Operating Chart
Soups*
Milkshakes
Blending /
liquidizing
(purees, drinks, batters)
Crushing ice
• Do not process for longer than recommended time.
• Do not exceed recommended maximum volumes.
• * Do not add boiling water and very hot liquids to the Plastic Jug, allow to cool first.
Preset programs running times
Dips & Sauces - 44 Seconds
Smoothies - 54 Seconds
Soups & Sauces - 58 Seconds
Ice Crush - 20 Seconds
10
All manuals and user guides at all-guides.com
Volume Speed (Manual)
Preset or Manual
1L 1-4+ pulse
1L 1-5+ pulse
1.5L 1-2 pulse
500ml max pulse
Care And Cleaning
• Before cleaning and maintenance, switch the appliance off and
unplug it, remove the Plastic Jug (5) from the Base Unit (7).
• After use, fill the Plastic Jug (5) with 1L (13⁄4 pints) of warm water
and run for 30 seconds on the pulse setting and repeat as
necessary. Never use abrasives or cream cleaners.
• Clean the Base Unit (7) with a damp cloth or kitchen paper roll.
• There is a facility to wrap your power cable around the base of the
product and fit the plug into the Plug Storage (15).
• Reassemble the Total Control Table Blender by carefully placing
the Plastic Jug (5) on the Base Unit (7), ensuring it fits correctly.
• WARNING : Never immerse the Base Unit in water.
• WARNING: If any liquid is spilt in the top of the Base Unit,
switch off and unplug from the socket and dry with a cloth.
Time
15 seconds to 1 minute max
15 seconds to 1 minute
15 seconds to 1 minute
10-20 seconds
Hints
Begin with low speed and
increase to high if required
Begin with low speed and
increase to high if required