Publicité
Les langues disponibles
Les langues disponibles
CONNECTION
-
With the devices disconnected from the mains, set the desired power setting to high impedance (100 V
or 70 V) or low impedance and select the desired low pass filter.
-
Connect the audio signal to the subwoofer INPUT; connect other devices to the OUTPUT if necessary.
IMPORTANT: for a correct operation and use of the device's features use the appropriate power,
impedance and frequency limits.
-
Before proceeding with the connection to other devices, take into account the necessary conditions in a
HIGH IMPEDANCE (100 V) and LOW IMPEDANCE installation.
More information can be found at:
-
With the volume controls set to minimum, connect the devices to the power supply and turn them on,
first the peripherals connected to the amplifier inputs (mixer, recorder, etc.) and then the amplifier.
-
Finally, adjust the volume and gain controls on all inputs and outputs until the desired sound is achieved.
-
Remember to turn off the device when it is not in use.
CONNECTION EXAMPLES:
100 V LINE
LOW IMPEDANCE
fonestar.com/downloads/install_fonestar_en.pdf
POWERBASS-8T
POWERBASS-8T
POWERBASS-8T
POWERBASS-8T
COM
100 V
COM
100 V
AMPLIFIER
AMPLIFIER
COM
6
COM
6
AMPLIFIER
AMPLIFIER
- 5 -
EN
Publicité
