Télécharger Imprimer la page

Hitachi Koki NR1890DRS Manuel D'instructions Et De Sécurité page 26

Cloueuse a bande sans fil

Publicité

Les langues disponibles

Les langues disponibles

[Auto power off ]
When the power is turned on but the Nailer is not
used for 30 minutes, the Nailer is automatically
turned off . To turn on again, press the power
switch.
Never leave the Nailer with the power on. This
could result in an accident.
Nailing operation indicator
Lighting (Blue):
FULL SEQUENTIAL ACTUATION MECHANISM,
Blinking (Blue):
CONTACT ACTUATION MECHANISM)
Make sure the battery indicator is not blinking.
If the battery indicator is blinking in red, the battery
doesn't have enough power and it needs to be
charged.
(4) Remove the fi nger from the trigger and press the
push lever against the workpiece with pulling back
the feeder knob.
□ THE NAILER MUST NOT OPERATE.
Do not pull
the trigger
Depress
push lever
(5) Separate the push lever from the workpiece.
Next, point the nailer downward, with pulling back
the feeder knob, pull the trigger and then wait in that
position for 5 seconds or longer.
□ THE NAILER MUST NOT OPERATE.
Pull the trigger
WARNING
Pulling back
feeder knob
Pulling back
feeder knob
(6) 1 Without touching the trigger, depress the push
lever against the workpiece with pulling back the
feeder knob.
Next, pull the trigger.
□ THE NAILER MUST OPERATE.
2 Hold the trigger back and depress the push
lever against the workpiece again.
□ THE NAILER MUST NOT OPERATE.
3 Separate the fi nger from the trigger.
Next, 1 is operated again.
□ THE NAILER MUST OPERATE.
(7) Separate the push lever from the workpiece, pull the
trigger.
Depress the push lever against the workpiece within
2 seconds.
□ THE NAILER MUST NOT OPERATE.
(8) Set the nailing operation indicator blinking ON mode.
(CONTACT ACTUATION MECHANISM)
Push the nailing operation switch once, make sure
that the indicator is blinking Blue.
Blink in blue
Separate the push lever from the workpiece, pull the
trigger.
Depress the push lever against the workpiece within
2 seconds.
□ THE NAILER MUST OPERATE.
(9) If no abnormal operation is observed, you may load
nails in the Nailer.
Drive nails into the workpiece that is the same type to
be used in the actual application.
□ THE NAILER MUST OPERATE PROPERLY.
English
25

Publicité

loading

Ce manuel est également adapté pour:

Nr1890dcNr1890dr