Télécharger Imprimer la page

MIRKA ARG-B 200 Instructions D'utilisation page 82

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 361
en (original)
Cleaning
Use a soft brush to remove any accumulated dust. Wear safety glasses to protect your eyes while cleaning.
If the body of the tool needs cleaning, wipe it with a soft damp cloth. A mild detergent can be used.
WARNING: Never use alcohol, petrol or other cleaning agent. Never use caustic agents to clean plastic parts.
Charger cleaning instructions
Dirt and grease may be removed from the exterior of the charger using a cloth or soft non metallic brush. Do not use
water or any cleaning solutions.
Further service
Servicing must always be performed by trained personnel. To keep the tool warranty valid and ensure optimal tool safety
and function, servicing must be carried out by a Mirka authorized service centre. To locate your local Mirka authorized
service centre, contact Mirka Customer Service, your Mirka dealer or go to www.mirka.com
Troubleshooting guide
Symptom
No light from the right LED of the
tool when trigger is pressed.
The right tool LED is red and the tool
slows down to the minimum speed
setting when grinding.
The right LED of the tool is red and
rpm is slightly reduced.
The left LED is red and the tool is not
running.
The left led of the tool is flashing red
although the battery is fully
charged.
Disposal information
82
Mirka® ARG-B 200 Cordless grinder
Possible cause
Battery pack not properly attached to
the tool.
Battery totally empty.
Temperature too high in the tool
Heavy load for too long.
Too heavy short term load.
The battery voltage is too low.
Battery failure. Please use the App for
diagnostics.
DANGER
Render redundant power tools unusable by removing the power cord.
Observe applicable country-specific regulations regarding disposal and recycling of disused machines,
packaging and accessories.
EU only: Do not dispose electric power tools in house-hold waste. According to European Directives
on waste electrical and electronic equipment and its implementation under national law, electric
tools that have reached the end of their life must be collected separately and taken to an environ-
mentally compatible recycling facility.
For more information regarding REACH, RoHS and our corporate social responsibility visit
www.mirka.com
Solution
Insert the battery properly.
Charge the battery.
Reduce the load on the tool for some
time and the tool will speed up again.
Use lighter load or wait a moment and
the LED will automatically change to
green.
Charge the battery.
Replace the battery.

Publicité

loading

Produits Connexes pour MIRKA ARG-B 200