MIRKA ARG-B 200 Instructions D'utilisation page 80

en (original)
Charger diagnostics
The charger will indicate if:
A battery pack is overheated. All three charging lights will flash. Remove the battery and allow it to cool down for 15 30
minutes and re-insert.
A malfunction occurs in the battery or the charger. Two charging lights will flash. Remove the battery and allow it to
cool down. Re-insert the battery pack into the charger. If two charging lights still flash, the battery or charger may
require service.
How to get started
When unpacking the tool, make sure it is intact, complete and has not been damaged in transport. Never use a damaged
tool.
Before use, check that the accessory is correctly mounted.
Install the fully charged battery pack into the tool until it locks in place with a click.
Operating instructions
The tool is intended to be operated as a hand held tool. The tool can be used in any position.
Select a suitable accessory and secure it to the tool.
The tool can now be activated / turned on and started by pressing the switch trigger.
The tool will run and stay in active mode as long as the trigger is pressed. After the trigger is released the tool will
deaccelerate until it stop but continue to stay in active mode for a short time before it automatically deactivates / turns
off.
When tool is in active mode the right LED is green.
If an intelligent battery is used all three LEDs will flash green for three seconds during startup.
In active mode the left LED shows the battery status:
Green: Battery charge level is OK.
Flashing green: Battery charge level is below 75%.
Flashing green/red: Battery charge level is below 50%.
Flashing red: Battery charge level or battery health (only available if intelligent battery is used) is under 25%.
Red: Battery voltage too low, tool is not operable.
The speed can be adjusted between 2500 and max 21000 rpm by adjusting the position of the trigger. In active mode
the max rpm can be adjusted by pressing rpm+ or rpm . The rpm can be adjusted in steps of 2500, 5000, 7500, 10000,
12500, 15000 and 21000 rpm.
The rpm can be locked to prevent an accidental rpm change. Wait until the tool is not in active mode. Simultaneously
press and hold both rpm+ and rpm buttons and then pull the switch trigger. In order to unlock the tool, repeat same
operation. If rpm+ or rpm is pressed in speed lock mode the right led flashes red twice but no speed change occur.
When grinding, if you just installed an accessory or are beginning a period of work, test it by letting it spin for one
minute before applying it to the workpiece. Allow accessory to come in to full speed before beginning work.
When grinding is finished, make sure the tool comes to a complete stop before laying th tool down. Remove the battery
from the tool by simultaneously pressing the button on both sides and removing the battery from the tool. Charge the
battery.
80
Mirka® ARG-B 200 Cordless grinder