MIRKA ARG-B 200 Instructions D'utilisation page 347

Replacing accessory
Installing collet
The collet must be attached to the collet nut before installing the collet assembly to the tool. Be sure that the collet size
matches the size of the mandrel you will use, otherwise the collet may break.
To assemble, place collet on an even surface, and place the nut over the collet.
1.
Press down on the nut to snap the nut and collet together.
2.
3. To disassemble, use a rod to push the collet out of the nut.
Installing accessory
Remove dust and debris from the collet body before inserting accessory.
1.
2. Insert the collet with the collet nut attached into the collet body. Thread the collet nut onto the spindle but do
not tighten it yet.
3. Clean the accessory mandrel, then insert it a minimum of 20 mm and 50% of accessory shaft length.
4. Hold the spindle shaft steady with a 14 mm open end wrench and securely tighten the collet nut with an 17 mm
open end wrench.
5. Reverse the procedure when removing the accessory.
Storage and handling
Storage in a dry place, protected from rain and frost. Keep free of pressure to avoid deformation.
Cleaning
Use a soft brush to remove any accumulated dust. Wear safety glasses to protect your eyes while cleaning.
If the body of the tool needs cleaning, wipe it with a soft damp cloth. A mild detergent can be used.
WARNING: Never use alcohol, petrol or other cleaning agent. Never use caustic agents to clean plastic parts.
Charger cleaning instructions
Dirt and grease may be removed from the exterior of the charger using a cloth or soft non metallic brush. Do not use
water or any cleaning solutions.
Further service
Servicing must always be performed by trained personnel. To keep the tool warranty valid and ensure optimal tool safety
and function, servicing must be carried out by a Mirka authorized service centre. To locate your local Mirka authorized
service centre, contact Mirka Customer Service, your Mirka dealer or go to www.mirka.com
Mirka® ARG-B 200 Cordless grinder
en | us-ca
347