Publicité
Les langues disponibles
Les langues disponibles
During the charging process, the charging lights will indicate the status as follows:
Three charging lights will flash in sequence during the charging process.
Fully charged, all three lights will remain on continuously.
The charging process will last approximately 50 minutes for BPA 10825/11125 and 100 minutes for BPA 10850/11150
battery pack.
NOTE! This charger can only charge Mirka 12V battery packs.
NOTE! Charging times may be longer depending on the surrounding temperature and battery conditions.
LED indication of BCA 108 charger
Charger diagnostics
The charger will indicate if:
A battery pack is overheated. All three charging lights will flash. Remove the battery and allow it to cool down for 15 30
minutes and re-insert.
A malfunction occurs in the battery or the charger. Two charging lights will flash. Remove the battery and allow it to
cool down. Re-insert the battery pack into the charger. If two charging lights still flash, the battery or charger may
require service.
How to get started
When unpacking the tool, make sure it is intact, complete and has not been damaged in transport. Never use a damaged
tool.
Before use, check that the accessory is correctly mounted.
Install the fully charged battery pack into the tool until it locks in place with a click.
Operating instructions
The tool is intended to be operated as a hand held tool. The tool can be used in any position.
Select a suitable accessory and secure it to the tool.
The tool can now be activated / turned on and started by pressing the switch trigger.
The tool will run and stay in active mode as long as the trigger is pressed. After the trigger is released the tool will
deaccelerate until it stop but continue to stay in active mode for a short time before it automatically deactivates / turns
off.
When tool is in active mode the right LED is green.
If an intelligent battery is used all three LEDs will flash green for three seconds during startup.
In active mode the left LED shows the battery status:
Green: Battery charge level is OK.
Flashing green: Battery charge level is below 75%.
Flashing green/red: Battery charge level is below 50%.
Flashing red: Battery charge level or battery health (only available if intelligent battery is used) is under 25%.
Red: Battery voltage too low, tool is not operable.
Mirka® ARG-B 200 Cordless grinder
en | us-ca
345
Publicité
