MIRKA ARG-B 200 Instructions D'utilisation page 344

en | us-ca
Battery pack
Intelligent battery
Noise and vibration information
Measured values are determined according to EN 60745.
Cordless
Sound pressure level (L
Sound power level (L
Sound measurement uncertainty
K
WA
Vibration emission value a
Vibration emission uncertainty K
*
Specifications subject to change without prior notice. Model range may vary between markets.
*
The values stated in the table are derived from laboratory testing in conformity with stated codes and standards and
are not sufficient for risk evaluation. Values measured in a particular work place may be higher than the declared
values. The actual exposure values and amount of risk or harm experienced by an individual are unique to each situ-
ation and depend upon the surrounding environment, the way the individual operates the machinery, the particular
material being worked, work station design and the user's exposure time and physical condition. Mirka accepts no
responsibility for the consequences of using declared values instead of actual exposure values for any individual risk
assessment.
Further occupational health and safety information can be obtained from the following websites:
https://osha.europa.eu/en (Europe) or http://www.osha.gov (USA)
Proper use of tool
This tool is designed for materials such as paints, metals, wood, stone, plastics, etc. Do not use this tool for any other
purpose than that specified without consulting the manufacturer or the manufacturer s authorized supplier. Do not use
accessories that have a working speed of less than the maximum rated speed of the tool's free speed. Any maintenance
or repair work requiring the motor housing to be opened may only be carried out by an authorized service center.
Battery and charger
The battery pack is not fully charged out of the carton. First read the safety instructions and then charge your battery
according to the instructions.
For optimal charging capacity the battery should be charged at an ambient temperature between 18 °C (64 °F) and 24
°C (75 °F). To prevent damage to the battery pack, do not charge the battery pack where the air temperature is below
4 °C (32°F) or above 40 °C (104 °F).
To obtain the longest possible battery life, we suggest the following:
Store and charge your battery in a cool area. Temperatures above or below normal room temperature will shorten
battery life.
Never store the battery in a discharged condition. Recharge it immediately after it has been discharged.
All batteries gradually lose their charge. The higher the temperature, the quicker they lose their charge.
If you store your tool for long periods of time without use, recharge the battery every month. This practice will prolong
battery life.
Charging procedure
Connect the power cord to the charger, and then plug into an outlet before inserting battery pack. All three charging
lights will be on for two seconds and then turn off.
Insert the battery pack into the charger. The lights will start to flash within 30 seconds.
344
Mirka® ARG-B 200 Cordless grinder
Mirka BPA 10825
Yes
ARG- B 200
) 70 dB(A)
pA
) 81 dB(A)
WA
3.0 dB(A)
* 2
11.1 m/s
h
2
1.5 m/s
PA
Mirka BPA 10850 Mirka BPA 11125
Yes Yes
Mirka BPA 11150
Yes