Publicité
Les langues disponibles
Les langues disponibles
CARE & MAINTENANCE
CLEANING
Ensure the appliance is unplugged before cleaning.
•
To clean the inside of the appliance, use a soft
cloth and a solution of a tablespoon of baking
soda to one quart of water or a mild soap
solution or some mild detergent.
•
Wash removable shelves in a mild detergent
solution, then dry and wipe with a soft cloth.
•
Clean the outside with a soft, damp cloth and
some mild detergent.
•
It is important to keep the area clean where the
door seals against the cabinet. Clean this area
with a soapy cloth. Rinse with a damp cloth and
let dry.
Note: Do not use cleaners containing ammonia or
alcohol on the appliance. Ammonia or alcohol can
damage the appearance of the appliance. Never use
any commercial or abrasive cleaners or sharp objects
on any part of the appliance.
POWER FAILURE
Most power failures are corrected within a few
hours and should not affect the temperature of your
appliance if you minimize the number of times the
door is opened. If the power is going to be off for
a longer period of time, take the proper steps to
protect your contents.
Note: Wait 3 to 5 minutes before attempting
to restart the refrigerator if operation has been
interrupted.
VACATION
•
Short vacations: Leave the appliance operating
during vacations of less than three weeks.
•
Long vacations: If the appliance will not be used
for several months, remove all items and turn
off the appliance. Clean and dry the interior
thoroughly. To prevent odor and mold growth,
leave the door open slightly, blocking it open if
necessary.
DEFROST
This appliance is equipped with an automatic defrost
function and does not require manual defrosting.
Defrost water from the appliance is channeled into a
drip tray located near the compressor. Heat transfer
from the compressor causes the defrost water to
evaporate.
MOVING
•
Remove all contents.
•
Use tape to secure the shelves inside the
appliance.
•
Turn the adjustable legs up to avoid damage.
•
Tape the door shut.
•
Be sure the appliance stays in the upright
position during transportation. Protect the
outside of the appliance with a blanket.
•
If the appliance is placed on its back or side
during transportation, upon reaching the
destination, allow it to remain upright for 6
hours before plugging in to avoid damage to
internal components.
DISPOSAL
This appliance may not be treated as regular
household waste, it should be taken to the
appropriate waste collection point for recycling
of electrical components. For information on local
waste collection points, contact your local waste
removal agency or government office.
8
Publicité
