Cutting Depth Adjustment - Panasonic EY3552 Instructions D'utilisation

Masquer les pouces Voir aussi pour EY3552:

Instructions d'utilisation (124 pages)

Table Des Matières

Table des Matières

Les langues disponibles

2.Press the switch lock lever down, then squeeze

the power switch to start the motor, and then

release the switch lock lever.

Switch

lock lever

Front grip

Fig.4

CAUTION:

• Check that the switch lock lever works.

If power switch can be activated without

depressing the switch lock lever, discontinue

use immediately. Take the tool to an author-

ized service center.

• Always hold the handle with one hand and the

front grip with the other. (See Fig.4) Maintain a

firm grip and depress the switch fully.

• The blade should not touch the cutting mate-

rial before you start the motor. Wait until the

blade reaches full speed before starting a cut.

• This tool has no provision to lock the power

switch in the "ON" position, and you must not

attempt to secure it in the "ON" position.

3.Start cutting when the blade reaches full speed.

4.During cutting, keep your cutting line straight.

Move the metal cutter forward at a steady speed,

while looking at the tip of the blade through the

transparent guard.

WARNING

•To prevent dangerous kickback, keep the

shoe of the metal cutter flat on the surface of

the material being cut.

•Never force the cutter. Use light and continu-

ous pressure.

5.If the motor starts to feel too warm, stop cutting.

Let the metal cutter cool down before continuing

work.

6.It is always a safe practice to remove the battery

pack after use and before storing the metal cut-

ter.