Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
base and use a spatula to press
the air bubble away from the
blades. Return the jar to the
motor base, replace the lid and
continue blending.
•
To stop the current blending
program, press the selected
program button again.
•
To switch to manual blending
mode during the blending
process, turn the knob to a
speed setting as needed.
•
To switch to pulse mode during
the blending process, turn the
knob to P several times.
6
Switch off the blender and unplug it
after blending.
» The blender stops blending
when the timer reaches 0:00.
7
Remove the blender jar from the
motor unit.
Note: Make sure the appliance is
completely stopped before
removing the blender jar from the
motor unit or the lid from the
blender jar. Do not blend more than
35 oz. thick puree. See
fig. 7 for maximum
quantity, suggested
preset blending mode,
suggested speed and blending time
of different recipes.
8
Open the lid by pulling up the
excess area of lid with your thumb
and pour out the ingredients from
the blender jar.
5
Manual blending
mode (Fig. 3)
1
Assemble your blender jar as
indicated.
•
The blender jar can be installed
in four different orientations. The
12
EN
handle can be aligned on either
the right side or the left side of
the front or back of the motor
unit.
•
When dome is used, the
blender jar can be installed in
two different orientations. The
handle can be aligned on either
the right side or the left side of
the front of the motor unit.
2
Put the ingredients in the jar.
Note:
•
Never fill the blender jar with
ingredients hotter than 104°F.
•
Do not exceed the maximum
indication on the blender jar.
•
Do not blend more than 35 oz.
thick puree.
•
See fig. 7 for maximum quantity,
suggested preset blending
mode, suggested speed and
blending time of different
recipes.
3
Insert the measuring cup into the
lid and turn clockwise to lock. Place
the lid onto blender jar and press
down firmly. Make sure the four
sides of lid are placed properly onto
the blender jar.
4
Put the plug in the wall outlet and
switch on the blender.
Note:
•
As a safety feature, if the blender
jar is not properly installed or if
the rotary knob is not at speed
0 before switching on, a flashing
"JAR" will appear on the timer
display. If this happens, make
sure the blender jar is installed
properly on motor unit. Turn
the rotary knob to speed 0 and
then switch on the appliance.
The timer shows a flashing "-:--"
and program LEDs turn on. The
appliance is ready to use.
Publicité
Table des Matières
