All manuals and user guides at all-guides.com
GB: DECK LUBRICATION:
The walking belt has been pre-lubricated at the factory. However, it is recommended that the walking board be checked
periodically for lubrication to ensure optimal treadmill performance. Please ensure
the lubrication of the running belt is checked every 4-6 weeks after the initial 100 miles/kilometers of use.
Every 30 days or 30 hours of operation lift the sides of the walking belt and feel the top surface of the walking board as far as
you can reach. If you feel signs of silicone, no further lubrication is required. If it feels dry to the touch, follow the instructions
below. Please use a non-petroleum based silicone.
To apply lubricant to the walking belt:
1. Position the walking belt so that the seam is located on top and in center of the walking board.
2. Insert the spray nozzle into the spray head of the lubricant can if a nozzle is required.
3. While lifting the side of the walking belt, position the spray nozzle between the walking belt and the board approximately 6"
from the front of the treadmill. Apply the silicone spray to the walking board, moving from the front of the treadmill to the rear.
Repeat this on the other side of the belt. Spray approximately 4 seconds on each side.
4. Allow the silicone to "set" for 1 minute before using the treadmill.