Battery Level Indicator; Attaching The Pushing Aid; Removing The Pushing Aid; Driving - Bischoff & Bischoff Togo 8010 Mode D'emploi

TOGO
| pushing aid

Battery level indicator

The lighting of the battery indicator indicates that the unit is ready for
operation and shows the current state of the batteries (fig. 08).
All LEDs light - max. charge
3 LEDs light - charging necessary
Pushing mode
08
The electrical drive is disconnected by pushing the lever downwards
(fig. 09). In this way, the pushing aid can be pushed without the
additional electrical drive.
09
After the lever is pulled back to the initial position, the drive engages
again.

5.2. Attaching the pushing aid

Thanks to its quick-release fasteners, the Togo pushing aid can easily be
attached to the wheelchair without using tools. Ideally, the wheelchair
user remains in the wheelchair during attachment.
• Apply the locking brake on the wheelchair.
• Switch off the drive unit on the pushing aid and unlock it for
10
pushing mode.
• Ensure that the locking mechanism is open.
• Move the pushing aid into the lower guide until it stops. The Togo
must be slightly tilted for this (fig. 10).
• Now lever the pushing aid into the upper guides (fig. 11).
• Locking occurs separately on the right and left. To do so, pull the
lever (to release) and then swing it upwards.
• Check that both sides are properly locked.
11
30
Caution! The braking function is non-operational as
a result.

5.3. Removing the pushing aid

Removing the pushing aid is as simple as attaching it. The wheelchair
user can also remain seated for this.
• Apply the locking brake on the wheelchair.
• Switch off the drive unit on the pushing aid and unlock it for
pushing mode.
• Open the locking mechanism.
• Now lever the pushing aid out of the upper guide (fig. 12).
• You can now pull the pushing aid completely out of the bracket
(fig. 13).
• The pushing aid removed can be folded for storage, for example in
a car luggage compartment, using a simple-to-operate lever (fig.
14).

5.4. Driving

In order to avoid toppling and dangerous situations, you should
initially practice safe handling of your new Togo pushing aid on a flat
and familiar surface.
• First select the speed (please use the lowest level to practice) and
the direction on the speed level switch.
• Switch on the pushing aid with the key switch.
• Release the locking brake on the wheelchair.
• The Togo starts smoothly by operating the control lever. Braking
occurs automatically by releasing the control lever.
• The wheelchair is steered by setting the direction on the push
handle.
This device is equipped with a surge protector. If
the device fails when under strain, please turn off
Togo and then turn it on again. Your Togo should
then be ready for use again.
Bischoff & Bischoff GmbH | 09.01.2020 - Revision: 1
TOGO
pushing aid |
12
13
14
15
31