Echo CS-330T Mode D'emploi page 14

RUNNING
WARNING
The saw chain should not move at idle, otherwise serious personal
injury may result.
NOTE
If saw chain moves, adjust carburetor according to "Carburetor
Adjustment" instructions in this manual, or see your dealer.
• After engine starts, allow it to return to idle and warm up before
using.
• Move chain brake lever fully rearward to unlock chain brake.
• Press throttle control lockout then gradually squeeze throttle
trigger to increase engine speed.
• Saw chain starts moving when the engine reaches approximately
4200 rpm.
• Ensure proper acceleration and lubrication of chain and bar.
• Do not run the engine at high speed unnecessarily.
• Be sure that saw chain stops moving when throttle trigger is
released.
STOPPING
1. Release throttle trigger (D) and move lever (A) rearward to
STOP (O) position.
2. Move chain brake lever (E) fully forward to lock chain brake.
NOTE
If engine does not stop, move ignition/choke lever forward to
choke position ( ) to stop engine. Return the unit to your
authorized ECHO dealer to check and repair stop switch before
starting the engine again.
All manuals and user guides at all-guides.com
14
D
E
D
A
A