ROBLIN MOLIERE Manuel D'utilisation page 12

For effective glass cleaning:
1. Perform initial cleaning using spe-
cific degreasing and non-abrasive
products;
2. To complete the cleaning, use a mi-
crofibre cloth moistened with water
(well wrung out), and finish clean-
ing.
Warning! Do not use abrasive agents or
chemical cleaners which could corrode
or scratch the surfaces of the device.
4. CONTROLS
Key Functions
A Switches the lighting system on and off to maximum brightness.
The Delay function is activated if the key is pressed for about 2
seconds. Ideal for eliminating any residual odours. Can be activated at
any speed. By pressing the key for a longer time, the automatic switch-
off function with a 5-minute delay is activated.
Press the speed key to disable.
It is possible to combine this function with the second speed to in-
crease extraction efficiency.
B Switches the extraction motor on and off to the first speed setting.
C Switches the extraction motor on and off to the second speed setting.
D Switches the extraction motor on to the third speed setting.
– Press and hold the speed setting button 3 for 3 seconds to obtain
a high operating speed with a duration of 6 minutes. The LED
flashes.
– Press and hold the switch for 3 seconds before the end of the 6
minutes to return to speed 3. The LED stays on.
– Press briefly before the end of the 6 minutes to switch off the
hood.
5. LIGHTING
• Please contact the Service Depart-
ment to change it ("Please contact
the service department to purchase
it").
• Lamps in risk group 1 under IEC/
EN62471 at a distance of 20cm and
in exempt from risk group under IEC/
EN62471 at a distance of 30cm.
12
LED
On/Off.
Flashes.
On/Off.
On/Off.
On/Off.
On/Off.