Publicité
Les langues disponibles
Les langues disponibles
Connecting to the Network Video Recorder
Important: To avoid networking problems, only use network switches
recommended by Avigilon.
Connect the camera to the same network as the server running the
Avigilon Control Center software. An IP address is automatically
assigned to the device, and will be detected by the software. For more
information on how to configure the connection, see the software user
guide.
The connection status LEDs show the progress in connecting to the
server and are described in the following table.
Table:Connection Status LED States
Connection
State
No Link
Off
Obtaining IP
One short
Address
flash every
second
Connecting to
Two short
a server
flashes every
second
Upgrading
Two short
Firmware
flashes and
one long flash
every second
Connected
On
8
All manuals and user guides at all-guides.com
Connection
Status LED
Not physically connected to any
network device
Attempting to obtain an IP address
An IP address has been obtained
and is attempting to connect to the
server
Updating the firmware
Connected to the server
Description
Publicité
