Télécharger Imprimer la page

cecotec CONGA 2299 ULTRA HOME GENESIS Manuel D'instructions page 54

Masquer les pouces Voir aussi pour CONGA 2299 ULTRA HOME GENESIS:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 60
ENGLISH
Recommendation
You can remove dirt from the high-efficiency filter with a small brush or gently shake the filter
on a hard surface to remove the dust. The high-efficiency filter cannot be washed.
Mesh primary filter and sponge filter. Fig. 8.
The filtering system is featured with a primary mesh filter and a sponge filter, located next to
the high-efficiency filter. It is suggested to replace them either after a maximum of 160 hours
of use or when they are worn out due to operation.
Recommendation
Dirt can be removed with a small brush or by shaking carefully against a hard surface for dust
to fall off. You can also use warm water without detergents to obtain better results. Always
make sure they are completely dry before installing them again; otherwise, moisture can reach
the robot vacuum cleaner's motor and damage it.
Cleaning the fall-detection sensors
Use a clean, dry and soft cloth to wipe off any dust from the fall-detection sensors located on
the robot vacuum cleaner's lower part.
Warning
Do not apply cleaning products directly on the sensors.
Cleaning the main brush. Fig. 9.
The main brush rotates at high speed and helps pulling the dirt into the suction mouth. This
brush is in contact with the floor, and therefore with dirt, so it can be worn out over time,
negatively affecting cleaning efficiency. For this reason, it is suggested to replace the main
brush after a maximum of 320 hours or less.
Slightly press the main brush frame's tabs in order to open the main brush storage gap
1.
and to remove it.
Remove hair, lint, and other dirt trapped in the brush and around the shafts with the help
2.
of the self-cleaning brush.
Clear and clean the robot vacuum cleaner's suction channel.
3.
Reinstall the main brush and its frame. 
4.
Recommendation
It is recommended to clean the main brush once a week with the help of the self-cleaning
brush.
Side brushes. Fig. 10.
Side brushes are designed with multiple bristles and are used to push dirt towards the suction
mouth and to thoroughly clean edges and corners. These brushes can wear out over time,
54
CONGA 2299 ULTRA HOME GENESIS

Publicité

loading