Hornbach Catania Manuel D'installation Et De L'utilisateur page 158

Once the desired pitch angle is
set with the setting nut, tighten
the upper lateral lock nut with
an hex wrench 17.
Repeat the same procedure on
the other arm of the awning.
Make sure to adjust the pitch
angle evenly on both sides, so
that the front profile (7) remains
horizontal.
Only follow steps 6 to 8 if the
angle of the front profile (7)
deviates from vertical:
Remove the protective caps
from the lock nuts at the inner
side of the front profile (7).
Loosen the lock nuts slightly
with a hexagon wrench 13 but
do not remove them.
158 | ENGLISH
4
5
6
6 - 8