Uline DOWNTOWN Serie Instructions D'installation page 4

11. Align holes on S-bracket (E) with pre-drilled holes on
left door. Insert two M3 x 12 mm screws and attach
using a Phillips head screwdriver or drill. (See Figure 8)
12. Align holes on lock (E) with pre-drilled holes on right
door. Insert two M3.5 x 16 mm screws and attach
using a Phillips head screwdriver or drill.
(See Figure 8)
Figure 8
E
Left Door
13. Using two people, hold door panel in line with side
panel. Attach hinge to side panel using four
M4 x 14 mm screws. Repeat for seven remaining
hinges. (See Figure 9)
Figure 9
PAGE 4 OF 12
ASSEMBLY CONTINUED
Unlocked Locked
E
Right Door
1-800-295-5510
uline.com
14. Once door panels are attached, each hinge may
need to be adjusted to align the doors. To adjust
the depth of the doors, tighten or loosen the rear
screw in the hinge. To adjust the angle of the doors,
tighten or loosen the center screw in the hinge.
(See Figure 10)
Figure 10
Side
Panel
Door
Door Depth
WALL ANCHOR
1. Attach one bracket of wall anchor (K) to back of top
panel using two M4 x 20 mm screws. Mark holes on
wall where plastic anchors are to be located. Drill
holes using 5/16" drill bit. Mount opposite bracket of
wall anchor to wall with two M4 x 40 mm screws and
two M8 x 36 mm plastic anchors. Tighten cable tie
to prevent tipping. (See Figure 11)
Figure 11
Top
Side
Panel
Door
Door Angle
Wall
Back
0723 IH-9189