Uline DOWNTOWN Serie Instructions D'installation page 2

NOTE: Assemble unit on a smooth, non-marring
surface to prevent scratching. Check that all
parts are included.
IMPORTANT! Turn cam lock 1/4 to the right to
lock. Ensure the arrow is pointing to edge of
panel before inserting into the panel's hole.
IMPORTANT! FUNCTION OF CAM LOCK
Ensure the arrow is pointing upwards
before inserting into the panel's hole.
IMPORTANT! Cam lock pins must be tightened
once inserted into panel. To tighten cam lock
pins, grasp lower part of cam lock pin and
tighten using a Phillips head screwdriver.
TIGHTENING OF CAM LOCK PINS
1. Insert cam lock pin (A) into bottom panel. Insert
cam lock (B) into skirt panel. Attach skirt panel and
tighten cam lock using a Phillips head screwdriver.
(See Figure 1)
NOTE: Cam lock caps (I) can be applied once
cam locks are tightened for a finished look.
Figure 1
PAGE 2 OF 12
1/4 RIGHT TURN
FOR LOCKING
Hold when
tightening
Skirt Panel
B
Bottom Panel
A
B
A
A
ASSEMBLY
2. Insert cam lock pins (A) and dowels (F) into back
panel. Insert cam locks (B) into bottom panel and
fixed shelf. Attach bottom panel and fixed shelf and
tighten cam locks using a Phillips head screwdriver.
(See Figure 2)
3. Align holes on L-bracket (E) with pre-drilled holes in
fixed shelf. Insert two M3 x 12mm screws and attach
using a Phillips head screwdriver or drill. (See Figure 2)
Figure 2
Bottom Panel
Back Panel
4. Insert cam lock pins (A) and dowels (F) into right
side panel. Insert cam locks (B) into bottom panel,
fixed shelf, back panel and skirt panel. Attach
panels and tighten cam locks using a Phillips head
screwdriver. (See Figure 3)
Figure 3
Bottom
Panel
Fixed Shelf
Fixed
Shelf
Back
Panel
B
E
B
F
A
A
F
Right Side
Panel
0723 IH-9189