Beurer EM 36 Mode D'emploi page 17

Taking a break during the training session
If you wish to take a break during a program, briefly press the Pause key. An acoustic signal sounds
and the pause symbol "II" symbol appears on the display. By pressing the key again you can conti-
nue the program.
Reading off the number of training sessions
You can read off the number of your training sessions on the display. The numbers after the program
denote how often you have already fully completed a program. These numbers are stored until there
is a battery change.
6. Cleaning
– Remove the batteries from the device every time you clean.
– Clean the device with a slightly moistened cloth. In case of more extreme soiling you can also
moisten the cloth with mild soapy water.
– Never drop the device.
– Ensure that no water penetrates into the machine. If this should ever happen, only use the machi-
ne again once it is completely dry.
– Do not use any chemical cleaners or abrasive agents for cleaning.
– Once you have removed the device (operating unit), you can clean the belt with a damp cloth. Use
mild soapy water or a liquid detergent for this purpose. Do not use bleaches.
– The belt is unsuitable for machine washing.
7. Technical Specifications
Model:
Power supply:
Electrode size:
Parameter (500 Ohm load):
Pulse duration:
Waveform:
Weight:
Belt size for waist measurement
Accessories:
Maximum permissible operating conditions: 0 °C to +40 °C, 20-65% relative humidity
Maximum permissible storage conditions: 0 °C to +55 °C, 10-90% relative humidity
Explanation of symbols:
Items included in the package:
Changes to the technical specifications introduced for reasons of updating without notice are reserved.
EM 35
3 x 1.5 V AAA (type LR 03)
approx. 11,3 x 6 cm: 7,8 x 9,7 cm
– Output voltage max. 70V p-p
– Output current: max. 140mA p-p
– Output frequency: 30 – 80Hz
200µs per phase
symmetrical, dual-phase square wave
~ 330 g
from 75 to approx. 140 cm
belt extension 40 cm
- Application part type BF
- Caution! Read the Instructions for Use.
- belt
- extension
- control
- batteries
- electrode cover
- these instructions for use
17