The Appliance And Environment; Maintenance; Defrosting - Electrolux ERC 2450 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GB
When closing the door of the frozen food
compartment take care to move its bolt in the
direction of the arrow to fit it to the lock properly.
Put foods into the appliance only in a closed dish.
Put warm foods into the appliance only when they
are at room temperature.
Keep the condenser clean at the back of the
appliance.

The appliance and environment

This appliance does not contain gasses which could
damage the ozone layer, in either its refrigerant circuit
or insulation materials. The appliance shall not be
discarded together with the urban refuse and rubbish.
Avoid damaging the cooling unit, especially at the rear
near the heat exchanger. Information on your local
disposal sites may be obtained from your municipal
authorities.
The materials used on this appliance marked with the
sympol
are recyclable.

Maintenance

Defrosting

Bleeding part of the moisture of cooling chamber in
form of frost and ice goes with the operation of the
refrigerator.
Thick frost and ice has an insulating effect, so it
reduces cooling efficiency as the temperature
increases, it needs more energy, at a certain
thickness it does not allow the door of the frozen food
compartment to open, possibly the door can be
broken.
At this type of appliance defrosting fresh food
compartment is automatic without any external
intervention.
The thermostatic control interrupts the operation of
compressor at regular intervals for more or less time -
during this cooling is interrupted - temperature of the
fresh food compartment increases and defrosting
occurs. After defrosting the thermostatic control
restarts operation of the system.
Melting water flows through defrost water outlet into
the evaporative tray maintained on the top of
compressor and evaporates due to warmth of it.
Check and clean the outlet of melting
water coming during defrosting regularly. If
it is clogged the melting water gathered can
cause earlier failure as it can go to the insulating
of the appliance.
Clean the melting water outlet with the supplied pipe
scraper that can be seen in the figure. The pipe
scraper has to be stored in the outlet.
Occasionally check defrost water outlet not to be
clogged up.
60

Hide quick links:

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

240-4s

Table des Matières