Publicité
Les langues disponibles
Les langues disponibles
6
Securing Bowl to the mounting blocks
Install the side screws to the mounting blocks.
Cover the screw head with the provided
screw-cap.
IF THE SIDE SCREW DOES NOT
HIT THE MOUNTING BLOCKS,
THEN TOILET BOWL IS NOT
FULLY INSERTED IN THE SOCKET.
If toilet is not installed properly, it may slide
out of socket or leak.
Please ensure that both sides are properly
fitted and secure. Be sure not to over-tighten
CAUTION
the screws, as it may results in product damage.
7
Connect Water Supply to the fill valve
Water supply must be connected to the fill
valve BEFORE tank to bowl installation.
• TOTO RECOMMENDS USING A FLEXIBLE
SUPPLY HOSE
• CAUTION! DO NOT OVER-TIGHTEN THE
COUPLING NUT. 1/4 TURN MAX AFTER
HAND TIGHTENING
Please be sure to connect water supply to fill valve
before installing tank to bowl. If procedure is re-
versed, water supply installation may be impossible.
FAILURE TO FOLLOW THIS INSTRUCTION MAY
CAUTION
RESULT IN PERSONAL INJURY AND/OR PROPERTY
DAMAGE.
8
Installing Tank to the Bowl
CONNECT WATER SUPPLY TO FILL VALVE BEFORE
INSTALLING TANK TO BOWL.
WHEN INSTALLING TANK TO BOWL, ENSURE THAT
CAUTION
TANK IS NOT TOUCHING THE BACK WALL.
• REMOVE WARNING STICKER FROM
BOWL
• Make sure fill valve nut and flush valve
nut are tightened properly. Install tank
to bowl gasket over flush valve outlet on
underside of the tank.
• Pick up the tank and carefully guide the
flush valve outlet into the bowl inlet on
the bowl tank-shelf. Make sure the bolts
on the bowl, fit through the opening in
the base of the tank.
All manuals and user guides at all-guides.com
9
1. Remove the top-portion of the flush valve for easy assembly by
2. Insert the rubber washer then metal washer on the mounting bolt.
3. Re-install flush valve and refill tube.
CAUTION
10
1. Connect opposite end of the water supply tube to angle
2. Open supply valve and flush toilet several times.
3. Carefully check all connections for leaks.
4. Periodically check for leaks several days following the
11
1. Carefully place lid on top of tank making sure
For replacement or readjustment of push rod height
2. Push down on one button, while pulling the opposite
3. Use the provided longer push rod, and insert them
4. Cut the push rod at the shown location.
5. Install the rods into the push buttons, and insert the
6. When inserting the buttons, make sure that the rod
12
1. Toilet seat is installed with top-mount bolt
Gasket
2. Insert the rubber bushing-nut into the
3. Place seat on bowl and rotate the hinge
4. Tighten the bolt from top with screwdriver.
Installing Tank to the Bowl
disconnecting the refill tube, turning the upper portion of the valve
counter-clockwise, and pulling up.
Thread on nuts, hand tighten before releasing the tank. Tighten
nuts evenly until tank sets snugly on the bowl.
Do not over-tighten the mounting bolt. Over
tightening may result in product breakage and
cause personal injury and/or property damage.
Water Connection
stop.
installation.
Lid Installation
that the push rod colors match the flush valve
buttons (blue to blue and white to white).
button up with your finger to remove.
thru push button housing.
buttons in the housing until they click into place.
colors match with the flush valve button colors (blue to
blue and white to white).
Seat Installation
set.
seatmounting holes.
unit into place while holding seat down on
bowl.
Water supply pressure should
be between 20psi & 80psi static.
Left
Right
Half flush
Full flush
Cut this portion
Seat Bolt
Rubber Bushing
Net
3
Publicité
