Eco-Flo EFSWJ5 Manuel Du Propriétaire page 2

Before you start
STOP
Fill Pump with water to prime: Ensure pump body is filled with water to discharge.
Motor's Electrical Settings: Set motor to proper voltage.
Help Line: Call 1-877-326-3561 for assistance
Important Safety Instructions Carefully read and follow all safety instructions in this manual and on pump.
SAVE THESE INSTRUCTIONS – This manual contains important instructions that should be followed during installation,
operation, and maintenance of the product. Save this manual for future reference.
This is the safety alert symbol. When you see this symbol on your pump or in this manual, look for one of the
following signal words and be alert to the potential for personal injury!
Indicates a hazard which, if not avoided,
will result in death or serious injury.
Indicates a hazard which,if not avoided,
could result in death or serious injury.
• Keep pump equipment out of the reach of children! Failure
to follow the directions given could cause serious risk to
individuals or objects.
• DO NOT work on pump until power is disconnected.
• DO NOT cut off ground pin or use an adapter fitting.
• DO NOT use an extension cord.
• The pump power cord should be connected to a sepa-
rately fused, grounded line with a minimum capacity of
15 amps. It can be connected to a non-fused breaker at
the recommended amperes.
• ELECTRICAL PRECAUTIONS - Before servicing the
pump, always shut off the main power breaker and then
unplug the pump. Make sure you are not standing in
water and are wearing insulted protective shoes under
flood conditions. Contact your local electric company or
a qualified licensed electrician for dicconnecting electrical
service prior to pump removal.
• Follow all local electrical and safety codes, as well as
the National Electrical Code (NEC) and the Occupational
Safety and Health Act (OSHA)
• Replace damaged or worn wiring cord immediately.
• Do not kink power cable and never allow the cable to
come in contact with oil, grease, hot surfaces, or
chemicals.
• Wire motor to correct supply. See motor nameplate and
wiring diagrams and check voltage of power supply.
• Unit must be securely and adequately electrically ground-
ed. This can be accomplished by wiring the unit to a
ground metal-clad raceway system or by using a separate
ground wire connected to the bare metal of the motor
frame or other suitable means.
For parts or assistance, call ECO-FLO Customer Service at 1-877 326-3561
All manuals and user guides at all-guides.com
SAFETY LABELS
NOTICE
Keep safety labels in good condition. Replace missing or
damaged safety labels.
GENERAL SAFETY
• Do not disassemble the motor housing. This pump has
• Make certain the electrical power source is adequate for
• Install pressure relief valve in the discharge pipe. Release
• The following may cause severe damage to pump and will
• This pump is only to be used for water systems.
• Protect the power cable from coming in contact with
• Do not run pump dry.
• Pump and plumbing must be full of water before startup.
• Do not pump water which contains sand, mud, silt or
• Be careful when touching the exterior of a motor. It may
• Do not allow pump or any system component to freeze.
2
Indicates a hazard which,if not avoided,
could result in minor or moderate injury.
indicates practices not related to personal injury.
continued
no repairable internal parts and disassembling may cause
leakage or dangerous electrical wiring issues.
the requirements of the pump.
all pressure on system before working on any component.
void the warranty.
- Using an extension cord.
- Cutting off the ground pin or using an adapter fitting.
- Working on the pump or switch while plugged in.
- Removing motor housing, unscrewing impeller or other
wise removing impeller seal
- Running the pump continuously.
- Pumping chemicals or corrosive liquids.
- Pumping gasoline or other flammable liquids.
sharp objects.
debris.
be hot enough to be painful or cause injury.
To do so will void the warranty.