Cooper Lighting Solutions PORTFOLIO LSRUD4B Instructions D'installation page 2

Installation Instructions – LSRUD4B/ LSSQUD4B Commercial LED Rough-In
INSTALLATION
LED and Trim assembly to be installed only after
N ote:
cylinder is installed.
Wall Mount Section
1. Install wall mounting plate to splice box using splice
box hardware (provided by others) and tighten to
17 IN/LBS torque when using 8-32 screw. Make
electrical connections to outlet box (Figure1).
2. Attach rear wall mount tether to splice box.
3. Mount cylinder housing assembly to wall by tightening
screws on top and bottom of arm base to 17 IN/LBS
torque to engage mounting plate.
Trim
1. Remove LED engine from protective packaging.
2. Remove trim assembly from protective packaging,
discard plastic trim ring, and rotate side clips (3)
outwards (Figure 3).
3. Insert LED engine on to trim assembly. Align post on
LED engine with slot on trim assembly (Figure 4).
4. Rotate side clips (3) into place to securely attach trim
assembly to LED engine (Figure 5).
Screw
Wall Mounting
Plate
Screw
Figure 1.
Luminaire
Quick
Disconnect
LED Engine
Trim Assembly
Figure 2.
2
Fiberglass
Sleeve
Torsion
Springs
Installation Instructions – LSRUD4B/ LSSQUD4B Commercial LED Rough-In
IB520124ML
Figure 3.
Figure 4.
Figure 5.
Figure 6.
www.cooperlighting.com
Side Clips