Publicité
Les langues disponibles
Les langues disponibles
PREPARE THE WALL
1.
Disconnect and move freestanding range from cabinet
opening to provide easier access to upper cabinet and rear
wall. Put a thick, protective covering over cooktop, set-in
range or countertop to protect from damage or dirt.
2.
Determine and clearly mark with a pencil the center line
on the wall where the rangehood will be installed.
3.
The Egyzia attaches to the wall by an "L" shaped bracket
(1 in FIGURES 5 and 6). This bracket has a small, threaded
hole in the top and must be mounted flat against the wall with
the hole on top and the flange pointing away from the wall.
If a backsplash is to be used with this rangehood, it must be
installed before the rangehood. Installation instructions for
the backsplash are supplied in its box. The height of the
backsplash will determine the bottom edge of the canopy.
4.
The chimney attaches to the wall by three "U" shaped
brackets (2, 3, and 4 in FIGURE 5). FIGURE 6 illustrates
FIGURE 5
6 5/16"
7 15/32"
8 21/32"
6 5/16"
B
FIGURE 6
4
3
2
1
4
3
2
1
the positioning of the chimney brackets. The largest bracket
should be installed about 1/8" away from the ceiling. The
middle bracket ( bright metal ) must be installed with the ends
touching the wall and the curves facing outward. The middle
bracket must be installed at the bottom point of the upper
chimney sleeve. The dimension X on FIGURE 6 should be
the length of the upper chimney sleeve.
When installed ductless without the chimney, these brackets
are not necessary. Determine the proper location for each
bracket and install the brackets on the wall.
5.
Determine and make all necessary cuts in the wall for
the ductwork. Install the ductwork before the rangehood.
6.
Determine the proper location for the Power Supply Cable
as indicated in FIGURE 7. Use a 1 1/4" Drill Bit to make this
hole. Run the Power Supply Cable. Use caulking to seal
around the hole. DO NOT turn on the power until installation
is complete. For remote blowers, a separate wiring cable is
required. DO NOT WIRE THE REMOTE BLOWER INTO
THE FIELD WIRING HOUSING OR CONNECT WITH THE
POWER SUPPLY CABLE.
90cm 35
120cm 47
FIGURE 7
INSTALL THE RANGEHOOD
1.
Remove the unit from the carton and place on a flat
surface for assembly. Cover the surface to prevent accidental
damage. Remove all parts including the mounting hardware
before discarding the carton.
2.
Remove the grease filters from the unit and set aside.
The grease filters are removed by pressing the handle in front
of the filter as indicated in FIGURE 8. When replacing, make
sure that the filters are properly positioned with the handles
in front and visible.
FIGURE 8
3.
Remove the cover from the field wiring compartment.
Remove the wiring electrical knockout using a flat-blade
screwdriver. Feed the Power Supply Cable through the
electrical knockout.
4.
Rotate the screws ( R in FIGURE 9 ) until half visible
above the plate. Hang the canopy on the bracket. Due to the
weight of the canopy, two people should lift it to avoid injuries.
Make sure the canopy is secure on the bracket.
7
/
"
3
4
3
/
"
8
/
"
1
4
Version 11/00 - Page 5
Publicité
