CASO DESIGN Wine Duett Touch 12 Mode D'emploi Original page 31

13.5.3 The handle installing
The wine cooler comes with 1 metal stainless steel handle. To install simply screw them to
the door with the supplied screws.
13.5.4 Wine shelves
Remove all bottles from the shelves. Lift the shelf upwards and the gently pull it out. Any of
the wine shelves can be removed to accommodate larger bottles.
13.5.5 To remove a shelf
Remove all bottles from the shelves. Lift the shelf upwards and the gently pull it out.
► Ensure that the tabs are firmly engaged in place before storing any bottles.
13.6 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
 The electrical outlet must be protected by a 16A safety cut-out switch.
 The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of fire that is involved with this.
 Make sure that the power cable is undamaged and has not been installed under or over
hot or sharp surfaces.
 This unit is not designed to be installed in an RV or used with an inverter.
 The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. Operations using an electrical outlet
without a protective conductor are prohibited. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a
missing or damaged protective conductor.
Please note
screw
handle
31