Publicité
GB
1. Front axle
Fix the steering levers with the axle plate. Push a bolt through the axle plate and through the
steering levers and secure with a nut. Tighten the bolt with a screwdriver (not included in the
scope of delivery) and the socket wrench (A).
2. Mounting the rear wheels
First mounting the rear wheels. Fit a washer (2), 2 shaft sleeves(16) and a washer (2) into the
axle. Fit a wheel (5) and a washer (2) onto the rear axle (15). Fit a nut (1) to the end of the axle
and tighten with a wrench (A).
Antriebsrad
Install the gear (6) on the right side of the rear axle (15). Fit a wheel (5) on the axle and secure
it with a washer (2) and a nut (1). Tighten the nut with a wrench (A).
3. Mounting the front wheels
Fit a washer (2) and a front wheel (5) onto the front axle. From the outside fi tted a washer (2)
and secured with a nut (1) gesichert. Tighten the nut with a wrench (A). Repeat this on the other
side.
4. mounting the handlebars, the armature and the ram protection
1. Fut the handlebars on the steering column Align it so that the holes on the
Match the handlebars with those on the steering column. Slide a threaded screw
through the hole and secure it with a nut. Now insert the steering column through the Hole in
the body and press until it clicks into place.
2. After pushing the handlebars through the car, turn the car around and put the handlebars
through the eyelet on the steering linkage. Secure with a washer and nut.
3. Position the fi tting on the body until it engages
4. Place the front bumper on the body in position and secure it with 4 screws.
5. Battery connection
Connect all connectors as shown. Only plug matching connectors into eachother and be sure
not to reverse the polarity. Make sure the red wire is well connected with the red terminal on the
battery, and same as the black one. Connect the motor cables (1) together. Cover the battery
compartment with the cover.
6. Assembly the seat
Place the seat in the position and save the seat with the seat lock.
Only use in direct supervision of an adult!
To control the vehicle a minimum skill level and caution is needed. Make sure you are familiar with the operation of the model and its characteristics. The model is heavy. This is an
increased risk of injury and damage in the event of loss of control. Avoid any kind of intentional or unintentional collisions with objects or hazards to persons.
Danger!
Always switch off the model immediately after each use. Immediately after each use, the batteries should be disconnected from the model.
The batteries can be deeply discharged by leaving them switched on accidentally or leaving them plugged in. Due to deep discharge, the
batteries lose power or can be damaged to such an extent that charging or discharging is no longer possible or the batteries can self-ignite
during the charging or discharging process (fi re hazard). Never attempt to charge or discharge deeply discharged batteries. The voltage of a
battery should never fall below 5,74 volts to avoid a deep discharge. The fully charged battery has a voltage of approx. 6,5 volts. After use, the
intact batteries should be fully charged immediately after a cooling phase of min. 10 minutes but at the latest after 12 hours to avoid a sub-
sequent deep discharge by self-discharge. If the batteries are not used or stored for a longer period of time, the batteries should be checked
for voltage (min. 6,2 volts) or damage at least every 3 months and recharged or disposed of if necessary.
Troubleshooting
1. The vehicle does not run
● The battery may low on power.
After each use, or once a month minimum, charge the battery. Do not
leave the battery on the charger for more than 12 hours.
● Thermal fuse has tripped.
The vehicle is equipped with a self-resetting fuse. When the
vehicle is overloaded or operated incorrectly; the self-resetting
fuse will be cut off for 5 - 20 seconds before becoming
operational again. The self-resetting fuse is under the seat
Cut off the power, follow these guidelines:
- DO NOT overload the vehicle, Maximum weight allowed: 25 kg
- DO NOT tow anything behind the vehicle.
- DO NOT drive up steep slopes.
- DO NOT drive into fi xed objects, which may cause the wheels to spin, causing the motor
to overheat.
- DO NOT drive in very hot weather, components may overheat.
- DO NOT tamper with the electric system, Doing so may create a short circuit, causing the
fuse to trip.
● Battery connector or wires are loose.
Make Sure the battery connectors are fi rmly plugged in to each other.
● Battery is dead.
Have you properly maintained the battery according to the directions? Is the battery old?
Your battery may need to be replaced.
● Electric system is damaged.
Water may have corroded the system, or loose dirt, gravel or sand might have jammed the
switch.
● Motor is damaged.
The motor needs professional repair.
7. Functions
A ON/OFF Switch
By pressing the ON / OFF switch (1) is the model on or off
B Sound button
C Switch button
Forward:
Press the switch button on the▲ position.
Press the gas pedal, the model drives forward.
Backwards:
Press the switch button on the ▼ position.
Press the gas pedal, the model drives backwards.
IMPORTANT!
Always stop vehicle when changing the speed or direction to avoid damage the gears
and motor.
D Accelerator pedal
Press the accelerator pedal to move the model. Remove the foot from the accelerator pedal
to stop the model
8. Charging your vehicle
•
The POWER SWITCH must be turned in OFF position when charging.
•
Plug the charger port into the input socket and plug the charger plug into a wall outlet.
The battery will begin charging.
•
The charge time is between 8 and 12 hours.
•
Do not charge the battery more than once within 24 hours
•
Charger and battery heat up during the charging process
Attention!
• Let the model cool off suffi ciently after each use before putting it back into operation.
When using an additional batteries let it cool off for minimum 15 minutes until the model
is operated again. Overheating can damage the electronics or may result in fi re.
• Always disconnect the model from the charger immediately after charging. Always
disconnect the charger from the power supply immediately after disconnecting the
model. Inserting the rechargeable model or charger after charging will result in damage
to the model, charger or the power supply (fi re hazard).
• Use the charger only in dry rooms.
2. The battery will not recharge
● Battery connector or adapter connector is loose.
Make sure the battery connector and adapter connector are fi rmly plugged together.
● Charger is not plugged in.
Make sure the charger is plugged into the wall outlet and the power fl ow to the outlet is on.
● Charger is not working.
Is the charger warm while charging? If not, the charger may.
3. The vehicle does not run very long.
● Battery may be undercharged.
You may not be charging the battery long enough. After each use, or once a month minimum,
charge the battery. Do not leave the battery on the charger for more than
12 hours.
● Battery is old.
The battery will eventually lose the ability to hold a charge. Depending on the amount of use,
and varying conditions, the battery should operate for one to three years. Replace the battery
with a new one.
4. Battery buzzes or gurgles when charging.
● This is normal and not a cause for concern. It may also be silent when charging, which is also
normal.
5. Charger feels warm when recharging battery.
● This is normal and not a cause for concern.
7
Publicité
