Publicité
Les langues disponibles
Les langues disponibles
Leveling of appliance
For sufficient leveling and air circulating
in the lower rear section of the
appliance, the bottom feet may need
to be adjusted. You can adjust them
manually by hand or by using a suitable
tool.
To allow the doors to self-close, tilt the
top backwards by 0.4" - 0.6".
0.4"~0.6"
Front roller
Adjustable
bottom feet
Door Removal
Tools you will need(Not provided)：
1.
Rear roller
2.
Adjustable
bottom feet
In case your home access door is too
narrow for the refrigerator to pass
through, remove the refrigerator doors
and drawers. If you do not need to
remove the appliance doors, proceed
to 'Installing Water Lines' on page 8.
If you need to remove the doors,
continue below.
Allen Wrench (5/32",4mm)
Philips Screwdriver
With the door closed, remove the 3 screws
holding the top cover (A) with Philips (+)
screwdriver, and then remove the top
cover with the entireharness attached.
Remove the screws (B) fixed on the hinges
with a wrench (5/16",8mm) and 1 ground
screw (C) attached to the hinge with
Philips (+) screwdriver. Remove the upper
left and right door hinges (D).
C
B
D
Wrench (5/16",8mm)
A
5
Publicité
