Thermador HMWN30 Instructions D'installation page 10

Fix Ducttotransitionand seal withtape. The integral motor blowers should be installed to the
For both installation method : hood with the hardware provided (Machine screws,
10.Wiring the HOOD: millimetric screws, millimetric nuts, motor bracket and
WABNING: spring) in the VIN600F and VTN1000F hardware bags.
To Avoid Electrical Shock Hazard
Turn off power at the service
panel before wiring this unit.
120 VAC, 15 or 20 Amp circuit
required. Millimetric nuts
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN '\,
ELECTRICAL JUNCTION BOX WITH 3
WIRES, ONE OF WHICH (GREEN/YELLOW) Machine screws ——» , 7 p
SERVES TO GROUND THE APPLIANCE.
A WARNING:
TOPROTECT YOU AGAINST ELECTRIC SHOCK,
THE GREENAND YELLOW WIRE MUST BE
CONNECTEDIO THE GROUNDING WIRE IN
YOURHOME ELECTRICAISYSTEMAND IT MUST
UNDERNO CIRCUNSTANCEBE CUTORREMOVED
Failure to do so can result in death or
electrical shock.
INTEGRAL VENTILATOR
INSTALLATION Models VIN600F & VTN1000F
The Integral ventilator can be mounted to
discharge air as show on figure 3 and 4b at page 9.
lt must be fixed through the slots of the ventilator
and pins with nuts of the hood.
Tighten the two nuts.
Machine screws ° @
r / Millimetric nuts |
¢— Motor Bracket
@ <+— Spring
8 +— Millimetric screws . Figure Sb
Install these components as is shown in the
picture 5a for VING6GOOF and 5b for VITN1000F.
Figure 5a