BOMANN BZ 6029 CB Mode D'emploi page 50

Problem Possible cause
Too much foam is The 5 litre party keg is not cold enough.
produced when
The 5 litre party keg was shaken.
dispensing.
The beer does not flow freely out of the tube.
The glass is held upright when dispensing.
The CO
Not enough foam The CO
is produced while
dispensing.
The beer is too cold.
There are grease, washing-up liquid or residues
in the glass.
The glass is too warm.
The glass is dry.
The beer turns The beer is too cold.
cloudy.
The beer hose is not clean.
The beer was incorrectly shock- chilled prior to
using the beer dispenser.
The beer is too warm. The keg was not chilled long enough.
The vents are covered. Insufficient space next to
and behind the dispenser.
The beer tastes flat. The CO
The best before date has expired.
The keg has been tapped too long.
The beer runs too The CO
slowly out of the beer
The CO
tap.
The beer does not flow freely out of the tube.
The dispenser does The dispensing unit is not correctly installed and
not close. protrudes from the dispenser.
It is difficult to install The keg tap was not moistened prior to tapping.
the dispensing unit on
the keg.
50
BZ6029CB_IM_new
pressure in the keg is too high.
2
pressure in the keg is too low.
2
pressure is too low.
2
cartridge is empty.
2
pressure in the keg is too low.
2
Solution
Cool the 5 litre party keg longer.
Allow the 5 litre part keg to stand in the beer
dispenser for a while.
Open the beer tap fully.
Tilt the glass when dispensing so that the beer
is able to run down the side of the glass.
Turn the pressure regulator to the " " position.
It takes some time until the pressure in the keg
is relieved and the amount of foam is reduced.
Slowly turn the pressure regulator towards " "
for 5 seconds.
Allow the keg to stand in the dispenser for
while. The temperature is then corrected by
the appliance.
Wash the glass thoroughly and subsequently
rinse with cold water.
Rinse the glass with cold water.
Rinse the glass with cold water.
Allow the keg to stand in the dispenser for
while. The temperature is then corrected by
the appliance.
Clean the beer hose.
Use a correctly chilled keg.
Chill the keg longer.
Uncover the vents.
Position the dispenser so that there is mini-
mum 15 cm space on all sides.
Slowly turn the pressure regulator towards " "
for 5 seconds.
Use a new keg.
Use a new keg.
Change the CO cartridge.
2
Slowly turn the pressure regulator towards " "
for 5 seconds.
Open the beer tap fully.
Install the dispensing unit correctly.
Wet the keg tap with cold water.
13.09.22