Publicité
Les langues disponibles
Les langues disponibles
1. Introduction
The control unit mod. BAX900L is a board developed to control rolling shutters in a easy and intuitive way. This product controls 230 Vac motors up
to 1000W. It is supplied with a courtesy light output. The product is compliant with the transmitters B.ro with 2 or 3 buttons. It is equipped with a pho-
tocells input and an input through molex connector for safety edge receiver.
WARNING : DO NOT INSTALL THE CONTROL UNIT WITHOUT READING THE INSTRUCTIONS FIRST !!!
2. Setting
Signalling
led
Jumper if the
safety edge is not
used
3. Electric connections
The control unit is supplied with all the inputs normally closed and jumpered to the common.
Before connecting a device to the control unit remove the jumper corresponding to the device that you want to
connect leaving the others unchanged.
L
11
1
12
N
13
2
14
6-1622605
rev.0
07/05/2013
All manuals and user guides at all-guides.com
Control unit BAX900L
Programmable control unit for rolling shutters
Connect the power supply cable between the
clamps 11 and 12 of the control unit.
Connect an eventual courtesy light between
the clamps 15 and 16 of the control unit.
ITA
ENG
Power supply 230 Vac 50Hz
Do not connect the card directly to the electric net-
work. Put a device which can ensure the disconnec-
tion of each pole from the power supply of the control
unit.
Connecting a charge of 230Vac 500W MAX it is
possible to light up the operating zone of the auto-
mation during each motion. The turning off is timed
with a period of 3 minutes. The counting is reset at
each impulse of up or down.
FRA
ESP
DEU
POR
2 / 8
Publicité
