Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Connection/Installation
Cautions
• Run all ground (earth) leads to a
common ground (earth) point.
• Do not get the leads trapped under a
screw, or caught in moving parts (e.g., seat
railing).
• Before making connections, turn the boat's
ignition off to avoid short circuits.
• Connect the yellow and red power supply
leads only after all other leads have been
connected.
• Be sure to insulate any loose unconnected
leads with electrical tape for safety.
Precautions
• Choose the installation location carefully so
that the unit will not interfere with normal
boating or car driving operations.
• Avoid installing the unit in areas subject to
dust, dirt, excessive vibration, or high
temperature, such as in direct sunlight or
near heater ducts.
• Select carefully the mounting location to
avoid internal damage by water entering
the unit. Areas subject to water splashes
should be avoided. The Waterproof Car
Stereo Cover (not supplied) is
recommended.
• Use only the supplied mounting hardware
for a safe and secure installation.
Note on the power supply lead (yellow)
When connecting this unit in combination with
other stereo components, the amperage rating of
the boat circuit to which the unit is connected must
be higher than the sum of each component's fuse
amperage rating.
Mounting angle adjustment
Adjust the mounting angle to less than 45°.
Parts List for Installation
• This parts list does not include all the
package contents.
• The bracket and the protection collar
are attached to the unit before shipping.
Before mounting the unit, use the release
keys to remove the bracket from the
unit. For details, see "Removing the
protection collar and the bracket"
(page 42).
• Keep the release keys for future use as
they are also necessary if you remove the
unit from your boat.
× 2
5 × max. 8 mm
(
7
/
× max.
5
/
in)
32
16
× 4
Max. size M4 × 6 mm
(
1
/
in)
4
39
GB
Publicité
Chapitres
Table des Matières
Dépannage
