EN
26
INSTALLATION
Before use
•
Make sure that the hood has not been damaged during transport.
•
The installation and connection of the electrical supply must be carried out
by qualifi ed professionals according to the manufacturer's instructions and in
compliance with local regulations.
Electrical connection
WARNING
Risk of electrical shock! Only connect this device to a properly
grounded outlet. If in doubt, consult a suitably qualifi ed technician.
Failure to follow these instructions can result in death, fi re, or
electric shock.
•
Do not connect the unit to the mains until it has been properly installed.
•
Never install the device if the voltage information (V) on the rating plate does
not match the mains voltage in your household. The type plate is located
inside the device, behind the grease fi lter.
•
If the cooker hood is equipped with a standard plug, connect it to an easily
accessible standard socket.
•
If the extractor hood is not equipped with a device plug, a two-pole, standard-
compliant switch with a minimum contact opening width of 3 mm must be
installed by a qualifi ed specialist in an easily accessible location.
•
When the cooker hood is connected to the mains, all indicator lights light up
briefl y and the cooker hood switches to standby mode (accompanied by a
beep).
Important information before installing the appliance
•
Clean the surrounding area thoroughly before and after installation so that no
dust or construction debris can be sucked in during commissioning.
•
Only set up the appliance in a suitable location.
•
Check the wall for load-bearing capacity.
•
Check the routing of electrical and other cables on and in the wall or ceiling so
that they are not drilled into.
•
Check the condition and load-bearing capacity of the electrical cables.
•
Have the device installed by a qualifi ed specialist.
•
During installation, strictly observe the minimum distance between the hob
and extractor hood (65-75 cm) and observe all instructions and notes on
installing the extractor hood.