Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
For easy installation, select an existing light operated
by a wall switch for replacement.
For best performance, mount the fixture about 8 ft.
(2.4 m) above the ground.
CAUTION: To Avoid Fire Or Burn Hazards:
• Allow fixture to cool before touching. The bulb and
the fixture operate at high temperatures.
• Keep fixture at least 1" (2.5 cm) from combustible ma-
terials. Do not aim at objects closer than 3 ft. (1 m).
• Use only T3, 150W (max.) tungsten halogen 120
VAC lamps.
For under eave installation, the sensor head must
be rotated as shown in the next two steps for proper
operation and to avoid the risk of electrical shock.
For eave mount only:
❒ Rotate the sensor head towards the clamp screw
joint.
Joint Clamp
❒ Then rotate the sensor head clockwise 180° so the
controls face down.
If the sensor pops out of the ball joint, loosen the
clamp screw and push the sensor back into the ball
joint. Tighten the clamp screw when done.
B
i
uLB
nstaLLation
NOTE: When re-lamping, turn power off and let the
fixture cool.
❒ Open glass covers. To remove the old bulb push the
bulb towards the right (with fixture as shown) until
the left side of the bulb is clear of the left socket.
❒ To install a bulb, push the bulb into the right socket
so the bulb fits completely into the left socket.
❒ Check that the bulb is seated properly.
❒ Close the glass covers.
All manuals and user guides at all-guides.com
❒ Turn power off at the fuse or circuit breaker.
❒ Remove the existing light fixture.
❒ Install mounting strap to junction box using screws
❒ The plastic hanger can be used to hold the fixture
❒ Thread all fixture wires through the large holes in
❒ Connect the junction box wires to the light fixture
Black to Black
Control Switch
Connect any fixture ground wire(s) and the cover plate
ground screw to the junction box ground wire.
❒ Place the mounting bolt through the front of the
❒ Make sure the wire connectors and wires are inside
❒ Push the rubber plug firmly into place.
❒ If not installed on a weatherproof box, caulk the
❒ Adjust the lamp holders by loosening the lock nuts
2
W
L
ire the
ight
appropriate for your junction box.
while wiring. The small end of the plastic hanger
can be threaded through the hole in the center of
the cover plate. The small end then goes into one
of the slots on the mounting strap.
the gasket as shown.
wires as shown. Twist together and secure with wire
connectors.
White to White
Gasket
M
L
ount the
ight
junction box cover.
the junction box. Align the mounting screw with the
center hole in the mounting strap. Secure the fixture
to the mounting strap.
wall plate and mounting surface with silicone.
Push the Rubber Plug over
the mounting screw.
Keep lamps at least 1" (2.5 cm)
from the sensor.
but do not rotate the lamp holders more than 180°
from the factory setting.
C
ontroL
Rubber
Plug
Mounting Bolt
C
ontroL
595-5730-05
Publicité
