Publicité
Les langues disponibles
Les langues disponibles
14. Troubleshooting
Fault
Possible cause
Motor does not work
Motor, cable or plug defective, the mains
circuit breaker switched off
The motor starts
Voltage too low, coils damaged, capaci-
up slowly and does
tor burnt
not reach operating
speed.
Motor makes exces-
Coils damaged, motor defective
sive noise
The motor does not
Circuits in the network are overloaded
reach its full power.
(lamps, other motors, etc.)
Motor overheats
Overloading of the motor, insufficient
easily.
cooling of the motor
Saw cut is rough or
Saw blade dull, tooth shape not appropri-
wavy
ate for the material thickness
Workpiece pulls away
Excessive cutting pressure and/or saw
and/or splinters
blade not suitable for use
34 | GB
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
Remedy
Arrange for inspection of the machine by a special-
ist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a special-
ist. Arrange for replacement of the capacitor by a
specialist
Arrange for inspection of the motor by a specialist
Do not use any other equipment or motors on the
same circuit
Avoid overloading the motor while cutting, remove
dust from the motor in order to ensure optimal cool-
ing of the motor
Re-sharpen saw blade and/or use suitable saw
blade
Insert suitable saw blade
Publicité
