Yamaha TT-R125 Manuel D'atelier Du Proprietaire page 244

BATTERY INSPECTION AND CHARGING
2
1
(TT-R125E/TT-R125LWE)
NOTE:
Since MF batteries are sealed, it is not possi-
ble to check the charge state of the battery by
measuring the specific gravity of the electro-
lyte. Therefore, the charge of the battery has
to be checked by measuring the voltage at the
battery terminals.
1. Remove:
Battery cover
G
2. Disconnect:
Battery leads
G
(from the battery terminals)
CAUTION:
First, disconnect the negative battery lead
1, and then the positive battery lead 2.
3. Remove:
Battery
G
4. Measure:
Battery charge
G
Measurement steps:
Connect a pocket tester 1 to the battery
G
terminals.
Tester positive probe →
Tester negative probe →
NOTE:
The charge state of an MF battery can be
G
checked by measuring its open-circuit
voltage (i.e., the voltage when the positive
terminal is disconnected).
No charging is necessary when the open-
G
circuit voltage equals or exceeds 12.8 V.
3 - 36
INSP
ADJ
battery positive terminal
battery negative terminal