Yamaha TT-R125 Manuel D'atelier Du Proprietaire page 192

OIL PRESSURE INSPECTION/PILOT AIR SCREW
ADJUSTMENT/ENGINE IDLING SPEED ADJUSTMENT
OIL PRESSURE INSPECTION
1. Check:
Oil pressure
G
Checking steps:
Slightly loosen the oil pressure check bolt
G
1.
Start the engine and keep it idling until oil
G
starts to seep from the oil pressure check
bolt. If no oil comes out after one minute,
turn the engine off so it will not seize.
Check oil passages and oil pump for dam-
G
age or leakage.
Start the engine after solving the prob-
G
lem(s) and recheck the oil pressure.
Tighten the oil pressure check bolt.
G
Oil pressure check bolt:
7 Nm (0.7 m • kg, 5.1 ft • lb)
PILOT AIR SCREW ADJUSTMENT
1. Adjust:
Pilot air screw 1
G
Adjustment steps:
NOTE:
To optimize the fuel flow at a smaller throttle
opening, each machine's pilot air screw has
been individually set at the factory. Before
adjusting the pilot air screw, turn it in fully
and count the number of turns. Record this
number as the factory-set number of turns
out.
Screw in the pilot air screw until it is lightly
G
seated.
Back out by the specified number of turns.
G
Pilot air screw:
2-1/2 ~ 3-1/2 turns out (example)
ENGINE IDLING SPEED ADJUSTMENT
1. Start the engine and thoroughly warm it
up.
2. Attach:
Inductive tachometer
G
To spark plug lead.
3. Adjust:
Engine idling speed
G
3 - 10
INSP
ADJ